Mozztronics BF-1 Bass Fuzz Pedal

Mozztronics BF-1 Bass Fuzz Pedal Australia
Split-path design. Dry blend retains low end. FZ-1 fuzz circuit. Phase switch. Hand made in Australia.
 
Most guitar overdrive pedals tailor the sound before and after the clipping stage. This results in a loss of bottom end, as too much bass in an overdriven sound can make the sound "flabby". This loss of bottom end makes these pedals less than ideal for use with bass.
This is the Mozztronics take on a pedal especially for bass players. The solution is to take the signal from the bass guitar and split it:
One path goes straight to the output via the DRY volume control
The other path goes through a high pass filter (to remove the flab from the overdrive) and then to a fuzz stage (the same fuzz circuit from the Classic Fuzz FZ-1 pedal)
This signal then goes to the TONE circuitry and to the WET volume control. By changing the levels of DRY and WET you can easily vary the balance between the two signals. A PHASE switch for the fuzz signal is also included.
By keeping the original signal, you retain a warm bottom end and add in as much dirt up top as desired.
 
Hand made in Melbourne, Australia by Mozztronics.
In stock at Guitar Garage Sydney. Ships Australia-wide.
 
Controls
FUZZ – amount of fuzz (barely on to full gnarly nastiness)
DRY – amount of clean bass signal
WET – amount of fuzz signal
TONE – adjusts treble in the fuzz signal
PHASE – selects whether fuzz signal is in phase or out of phase with original signal
 
Key Features
Split-path design for bass
Clean dry signal path retains warm bottom end
High pass filter removes flab from fuzz path
Fuzz stage uses same circuit as FZ-1 Classic Fuzz
Independent DRY and WET volume controls
PHASE switch (in/out) for fuzz signal
TONE control for fuzz signal treble
FUZZ from barely on to full gnarly nastiness
Designed specifically for bass players
Hand made in Australia