Mozztronics BOD-1 Bass Drive Pedal

Mozztronics BOD-1 Bass Drive Pedal
Split-path design. Dry blend retains low end. Double clipping stage. Contour switch. Hand made in Australia.
 
Most guitar overdrive pedals tailor the sound before and after the clipping stage. This results in a loss of bottom end, as too much bass in an overdriven sound can make the sound "flabby".
 
This is the Mozztronics take on a pedal especially for bass players. The solution is to take the signal from the bass guitar and split it:
 
One path goes straight to the output via the DRY volume control
The other path goes through a high pass filter (to remove the flab from the overdrive) and then to a double clipping stage—as the signal level increases, each different clipping stage contributes accordingly
 
This signal then goes to the CONTOUR circuitry and to the WET volume control. By changing the levels of DRY and WET you can easily vary the balance between the two signals. By keeping the original signal, you retain a warm bottom end and add in as much dirt up top as desired.
 
Hand made in Melbourne, Australia by Mozztronics.
In stock at Guitar Garage Sydney. Ships Australia-wide.
 
Controls
GAIN – amount of overdrive (barely on to full shred)
DRY – amount of clean bass signal
WET – amount of overdriven signal
CONTOUR – switch for bright or normal overdrive
 
Key Features
Split-path design specifically for bass
Clean dry path retains warm bottom end
High pass filter removes flab from overdrive path
Double clipping stage with progressive contribution
Independent DRY and WET volume controls
CONTOUR switch (bright/normal overdrive)
Retain original bass tone while adding dirt on top
Designed specifically for bass players
Hand made in Australia